Strong for Constant Moisture
A Tile Backer Board for Wet Areas is built for pools and spas. This backer board has a fiberglass mesh on both sides. The Tile Backer Board for Wet Areas uses a high-density foam core. The core does not soak up water at all. You can put this board in a fountain or a water feature. The board stays stiff even after years of wet use.
Easy to Seal Joints
The product has square edges. You put the boards next to each other. Then you fill the gap with a special sealant. The sealant dries into a waterproof membrane. The product also accepts screws very well. The foam grips the screw threads. The screw does not pull out. You can use standard drywall screws with this board. No need for special fasteners.
Good for Commercial Pools
A product does not break down in chlorine. This backer board resists pool chemicals and salt water. The product has a 20 year warranty for submerged use. You can put it behind waterline tile in a swimming pool. The board does not swell or warp. Buy this product for your hotel pool project. It will outlast the grout.
Technical Data Table
|
Parameter |
Value |
|
Core Density |
45 kg/m³ |
|
Mesh Type |
Alkali-resistant fiberglass |
|
Joint Sealant |
Silicone or polyurethane |
|
Screw Type |
Standard drywall screw |
|
Water Absorption |
<0.5% by volume |
Hot Tags: tile backer board for wet areas, China tile backer board for wet areas manufacturers, suppliers, factory, fiber cement waterproof board, glass fiber cement board waterproof, impact resistant waterproof wall backer board, tile backing waterproof cement board, wall tile waterproof cement board, waterproof cement backing board
